Aico Ei Ei168RC Installationsanleitung PDF herunterladen (Seite 14)

prevent air draughts affecting the smoke/heat entering

the alarm. If the hole is too large or the alarm does

not seal it, it should be sealed with silicone rubber or

equivalent.

6. Replace the wiring cover. Check the alarm battery is

connected (Ei141RC/144RC/146RC only).

7. Carefully line up the unit on the base and slide on.

8. Press and hold the test/hush button for 10 seconds.

The horn will sound. On release of the test button the

local alarm will stop sounding immediately and the

interconnected Alarms will stop sounding a few seconds

later.

9. Connect the mains power to the alarm circuit. Check

the green light is on.

10. Attach the ‘Smoke Alarm’ identification label

provided to the distribution board to identify the alarm

circuit.

11. Attach the ‘Mains Smoke / Heat Alarms’ label

provided on or near the distribution board and write in

date installed and the number of alarms on the circuit.

Ensure the alarm operates correctly - see “TESTING &

MAINTAINING YOUR ALARM” section on page 4 of

the USER INSTRUCTIONS.

4.2 Interconnecting Alarms

Note: A maximum of twelve Ei141RC/144RC/146RC

/161RC /164RC/166RC Smoke or Heat Alarms may be

interconnected. Up to 8 additional accessories may also

be connected (see “ACCESSORIES” section).

If you wish to connect more than twelve alarms contact

your local distributor (see page 16 for details).

Systems using more than 3 or 4 alarms must be very

carefully planned to ensure nuisance/false alarms are

not excessive. e.g. from cooking fumes or steam. The

following is suggested:

• Smoke Alarm Control Switch (model Ei1529RC)

should be incorporated into the system and be readily

accessible to all occupants so that the source of an

alarm can be quickly identified.

• All alarms must be cleaned and maintained regularly.

• A qualified person must be on call to quickly remove

any nuisance units (i.e. units with red light flashing

rapidly) which are causing all the other alarms to

sound.

WARNING: Do not connect these Alarms to any

other type of Ei Alarm (apart from those listed

above) or to any other model produced by another

manufacturer. Doing so may damage the Alarms

and could result in a shock or fire hazard.

Wiring must be installed in compliance with local

regulations.

1 2 ... 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Aico Ei Ei168RC Installationsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Rauchmelder Aico Ei Ei168RC